We all know that LCD and LCD TV to use such products more squeamish, if you not pay attention to maintenance, it may be that your LCD monitor to use a short time, then how to make your LCD monitor to use it longer, the following I'll have to tell you some to use your LCD monitor longer way!
We all know that LCD and LCD TV to use such products more squeamish, if you not pay attention to maintenance, it may be that your
LCD monitor to use a short time, then how to make your LCD monitor to use it longer, the following I'll have to tell you some to use your LCD monitor longer way!
The first is your use of the environment. To avoid static damage to your equipment generates and can not be placed in a very long time to run dry place. And does not make the air humidity is too large, so will accelerate the aging of electronic devices or even unusual, not normal use.
General electronics work required to maintain 30% humidity 80%. When, after more than 80% humidity, it may cause damage to electronic equipment. LCD display on the humidity requirement is stringent. If you work long hours in high humidity conditions, may make an exception LCD display focus more severe cases may cause damage to LCD monitors can not be restored completely. Give us cause economic losses, affecting the normal operation of your equipment.
Again a lot of users are in the habit of the glasses, "breath" and then with the glasses cloth to clean the glasses, so do cleaning LCD sometimes also used the same approach, but you may not know this approach on the LCD of the injury is very large. LCD screen can not use the water and alcohol or special cleaning agents to carry out clean, because these solutions will make LCD monitors moisture. If you frequent use of "breath" method to clean the screen surface water will condensate gas, so LCD is exposed to moisture on the increase, a long time the focus will affect the LCD was like.
There is a long time in the user not to use LCD, the LCD monitor if they have been damp, and we must immediately use special lens soft damp cloth to gently wipe off site to open after the power supply. If the water vapor condensate product of the situation is very serious, and has entered the internal
LCD, you have to be put to the LCD was warm and dry and ventilated place, such product can LCD in the condensate water so evaporated. If we directly use the already damp water of LCD, LCD is easy to cause your resulting electrode is corrosion damage to your LCD monitor can not be used.
| Additional articles about LCD |
|
|
| About the author |
http://www.super-e-world.com/LCD-Monitor/
|
| Please Rate This Article |
Number of ratings: 0
Rating: 0